The Satin American etc-12/etd retrofit system is the safest, most feature-rich and user-friendly circuit breaker retrofit system on the market.
Safety features include:
- A standard detachable display that can be mounted remotely, permitting setup and monitoring from outside the breaker cubicle and reducing the NFPA-70E arc-flash hazard category from level 3 to level 0.
- Standard mechanical automatic reset eliminates the need to open the cubicle door to reset after an overload.
- Standard flashSAFE arc-flash reduction allows the user enable lower the instantaneous pickup on a closed breaker, reducing the potential for arc-flash exposure downstream of the breaker.
All etc-12 programmers come standard with full LSIG functions and can be utilized on any breaker frame size and with multiple current sensor secondary ratings. The unit does not require ratings plugs and unneeded protection bands can be disabled. In addition, the etc programmer is equipped with many advanced capabilities that that can be utilized at any time though the purchase of low cost and easy to install modules. These features include:
- Bi-directional MODBUS communications with open source protocol that can be integrated into many existing faculties management software packages.
- Latching, form-C contacts for trip indication.
- Remote trip ability.
- Selective zone interlocks.
- Lockable flashSAFE activation module.
- Hardware interlock for preventing settings changes.
The etc retrofit system is designed to be easy to setup, use and test.
- Clear directions and 24/7 technical support provided by individuals that have actually retrofitted and tested breakers, not someone reading off a pre-written script.
- Many kits are available that use existing sensors, copper and flux devices, eliminating waste and reducing cost and complexity.
- Unique “Test Mode” that permits any of the following functions to be defeated with the press of a single button; ground fault, phase imbalance, short-time, and instantaneous.
- Detachable display that can be placed directly in front of the test technician, allowing one person to test pickup and metering.
- Intuitive setup menu that clearly shows settings both as percentages and in amps.
- Back-light display for use in areas with low light.
- Real-time display of ground current.
- Standard multi-tapped CT’s and a vast number of settings allow the unit to be set up to match the time-current curve of any overload or solid-state trip.
|
